top of page

Part-Winding Start Pump Control Panels

Part Winding Pump Control Panel

Product Description

A Part-Winding pump control panel is a “combination starter” that combines a part-winding magnetic starter along with a fusible switch.

​

Our pump panels offer protection against short circuit faults, protection against motor overload faults, and means of disconnecting the motor and the controller from the power supply lines.

​

Part-Winding motor starters (or two-step starters) provide economical reduced current starting in applications where the supplied power restricts the increments of current drawn from the lines, and a simple method of accelerating loads with low starting torque.

​

These controllers require a motor suitable for Part-Winding Starting.

Standard Features

  • Type 3R enclosure for use outdoors. Rain and sleet resistant. Fully welded steel construction with hinged door and provisions for padlocking​​

​

  • Gray powder-coating finish suitable for use in harsh environments​

​

  • Choice of disconnect style: Fusible Switch​

​

  • Fusible Disconnect Switches include factory-installed J-Class time-delay dual-element current-limiting power fuses

​

  • Through the door rotary disconnect operator with provisions for padlocking in the off position​

​

  • Part-Winding Magnetic Motor Starter with choice of coil voltage​

​

  • (2) Solid State Class 10 Overload Relays with adjustable trip point and inherent protection against loss of phase​

​

  • Fast-Acting Supplementary Fuses for protection of internal and external control circuit wiring against damage due to short circuits and ground faults​​​

​

  • Hand-Off-Auto Selector Switch

​

  • Grounding Lug

​

  • UL 508 Listed Industrial Controls​

​

  • Suitable for use as Service Equipment

  1. Fusible Type Panels include J-Class Power Fuses

  2. Unless otherwise specified, Starter Coil Voltage is the same as line voltage

  3. Call factory for HP and Voltages not shown​​​​

bottom of page